Tri band sigbal booster, 4 dual frequencies to choose.
Please check the frequency of your operator before placing order.
FREQUENCY DO NOT MATCH, IT CAN NOT WORK.
Please leave a massage about which plug you need when place order.
If no messege left in the order, we would send the plug in accordance with our experience.
GOBOOSTCellular Signal Booster
10 Core Features
1.70dB High gain,21dBm output power.
Supper Appearance With Metal Design
Effectively reduce clutter radiation and ensure stable output of host power.
ALC Intelligent Control With Extraordinaty Board
Extraordinary board with intelligent code. It will according to the input signal strength to adjust itself.
-10° to -55° Cold and heat resistant, durable and tough
70dB High Gain
Wide coverage with strong penetrating power. Cover 300~600 square meters without any barriers.
Daily Radiation Value Of Electronic Products
The lower the radiation value is, the better, the safer.
QUICK HEAT DISSIPATION
Make GOBOOST Booster More Duarabale Servicing To You.
PLAY GAMES WHILE CAILING
With 21dbi output power to make sure safety and stability.
Step1:Search a position where can receive good signal(stronger than -70dB)Parallelly installing the outdoor antenna on that location,towards to the base station or cell tower.
Step2: Use 10m cable to connect the outdoor antenna and singal booster.Please ensure they were tightenned joints,connected well. Step3:Connect the indoor antenna and the singal booster.
Step4:After finished all parts then check weather all connectors well,then can turn on the power.
Two antennas need to separate by brick wall. The distance between them at least 10 meters.
Easy Setup in 4 easy steps!
Step 1 Install And Point Outside Anrenna Toward Nearest Cell Tower
Please find the location outside where you have the strongest signal on your phone. And make sure you can get at least 3 bars (stronger than -70dB) signal of outdoor. Parallelly installing the outdoor antenna on that location,towards to the base station or cell tower.
Step 2 Cable runs to Repeater
Use 10m cable to connect the outdoor antenna,then connect to the port on GOBOOST singal booster labeled “BTS”. Please ensure they were tightenned joints,connected well.
Step3 Connect the Internal Antenna
Connect the indoor antenna to the port on GOBOOST singal booster labeled “MS” or “Mobile”.
Step4 System commissioning
After finished all parts then check weather all connectors well,then can turn on the power.
1. RECEIVES SIGNAL
The powerful antenna reaches out to access a good signal, and delivers it to the booster.
2. BOOSTS SIGNAL
The booster receives the signal, amplifies it, and serves as a relay between your phone and the nearest cell tower.
3. BROADCASTS SIGNAL
Your devices get increased cell reception, and calls and data are fed through the booster back to the network.
signal bar of the screen flash or show blank
|1.The frequency of signal repeater and phone should be match.
2.Choose corresponding network mode to test.
3.Make sure oudoor signal more than 3 bars. Adjust the outdoor antenna and point it to base station.
Signal bars are full bars,
but can not make phone calls
|1.Increase the distance between two antennas,preferably more than 15 meters.
2.No open windows or doors,otherwise will cause signal interference.
3.If the solutions above not work,please try putting repeater & indoor antenna into a room.
Work for a while, but suddenly stop working
|1.Check if water in the interface of ourdoor antenna and cable.
2.Check if power supply works normally;Please test the power supply of the same voltage and current.